Jeep Tj Transfer Case Not Shifting. Transfer case lever moves between 2h, 4h, and n with not much problem. i would take off the boot around the transfer case shifter. It may not be that, but it's something to check, take that little bolt off and shift. (3) loosen lock bolt on. if the block is not sliding on the rod, pb blaster is your friend. (make sure your shifter is fully in the 4l position) (2) raise vehicle. (1) shift transfer case into 4l position. as far as shifting the transfer case into neutral, 4 lo, or back to 4 hi from n, im pretty sure you need to put the. You should see this gate. the transfer case (or more accurately, the selector lever) was balky but i wasn't worried about it at the time,. Spray the shiat out of it, maybe even ove rthe course. i was shifting it with the case apart and it shifted fine into all gears,l but once its together it won't. Its just a piece of metal. there is a rod that slips into the sye and it may not be aligned properly. There is some effort that.
from www.youtube.com
Transfer case lever moves between 2h, 4h, and n with not much problem. There is some effort that. i would take off the boot around the transfer case shifter. Spray the shiat out of it, maybe even ove rthe course. as far as shifting the transfer case into neutral, 4 lo, or back to 4 hi from n, im pretty sure you need to put the. (make sure your shifter is fully in the 4l position) (2) raise vehicle. I don't see how i. You should see this gate. It may not be that, but it's something to check, take that little bolt off and shift. (1) shift transfer case into 4l position.
Jeep TJ Transfer Case Shifter Linkage Is MANGLED.. Time To Repair It
Jeep Tj Transfer Case Not Shifting i was shifting it with the case apart and it shifted fine into all gears,l but once its together it won't. as far as shifting the transfer case into neutral, 4 lo, or back to 4 hi from n, im pretty sure you need to put the. I don't see how i. (make sure your shifter is fully in the 4l position) (2) raise vehicle. You should see this gate. i was shifting it with the case apart and it shifted fine into all gears,l but once its together it won't. there is a rod that slips into the sye and it may not be aligned properly. the transfer case (or more accurately, the selector lever) was balky but i wasn't worried about it at the time,. (1) shift transfer case into 4l position. if the block is not sliding on the rod, pb blaster is your friend. Spray the shiat out of it, maybe even ove rthe course. Transfer case lever moves between 2h, 4h, and n with not much problem. It may not be that, but it's something to check, take that little bolt off and shift. Its just a piece of metal. i would take off the boot around the transfer case shifter. There is some effort that.
